But Ed, does it mathematically show that you now want to install a restrictor plate?

Or are you sticking to this original statement?: The entire ideal is to transfer heat from engine to air.  Holding the coolant longer in the block (via a flow restrictor) will indeed increase the temperature and therefore the heat content of the coolant.  However, my view is the ideal is NOT to hold the heat in the block but to promote its rapid exit from the block to the radiator. 

Jeff

 

 

Here is a formula for a centrifugal pump that clearly? Shows that Tracy and Lynn are correct

 

Energy Usage

The energy usage in a pumping installation is determined by the flow required, the height lifted and the length and characteristics of the pipeline. The power required to drive a pump (P_i), is defined simply using SI units by: by:

where:

P_i is the input power required (W)

ρ is the fluid density (kg/m³)

g is the gravitational constant (9.81 m/s²)

H is the energy Head added to the flow (m)

Q is the flow rate (m³/s)

η is the efficiency of the pump plant as a decimal

 

One can see that if Q the flow rate becomes zero (by blocking the exit) then the power required to drive the pump Pi also becomes zero.  So block the pump and lower the flow and the power required drops – or with the same power, the pump can spin faster.  There is always some flow around the vanes of a centrifugal pump in reality, so the power does not cause the pump to spin to infinity rpm but it equalizes at a higher rpm than when considerable (unblocked) flow is the condition.

 

Is this fun or what?

 

NO!  I meant exactly what I wrote.  It is admittedly counter-intuitive but true none the less.  Did you attempt to prove it to yourself with the suggested test?   Only takes a few seconds :>)

Tracy

__________ Information from ESET NOD32 Antivirus, version of virus signature database 3267 (20080714) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com