|
|
SNIP
At the rate I'm going, it looks like Ed will have his engine re-built,
installed and flying before I get mine started.
Bob W. (Moving slowly and unsurely)
-- http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)
Well, Bob, I did finish the engine rebuild tonight and loaded it in the Van. However, this is the 3rd time I've opened up and close up a rotary, so its not quite the challenge the first one was {:>).
Go slow and get it right, is much better than going fast and getting it wrong {:>)
Hopefully the installation will go without a hitch. I intend to just install the engine and hook everything up, drive back home and go out the next day with the prop and other stuff. May make a short flight around the pattern then land and check for any problems. Drive home and have the wife drive me back the next day - so I can fly it home.
Sounds like your water pump is going to do the job with acceptable current load. Looking forward to the results on the engine
Ed A
|
|