Another question for those who have gone
before.
The L360 manual which I am using, in the section on the
header tank construction, says that I may seal the inside of the tank with
primer and then tank sealer (“PRC 1422” is suggested), or with “two
thick coats of resin” (page 11-34).
I am interested in what others have found to be the best
way to go. As I live in Australia, the resin option is much easier than
importing the sealer. However, I suspect there may be more to this decision
than just the cost and simplicity advantages of resin. I would really
appreciate any advice that others may be willing to offer.
Thanks again.
Rob Stevens
Perth
Western Australia.