Thanks Ben. I think the outer ports could be 1.75" and the center port
1.5" if the holes in the flange were smaller. The engine exhaust inserts
add a lot of area to the rectangular openings. I may cut a new flange
with smaller holes after taking new measurements. Bobby -----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of Ben Schneider
Sent: Sunday, July 26, 2009 6:54 AM
To: Rotary motors in aircraft
Subject: [FlyRotary] Last Picture I promise

This is the final picture, I promise.