|
Hi John,
I have often thought that perhaps two of those cones in a 3" tube might
provide sufficient lowering of the noise level. However, having two tubes,
that would mean 4 cones and a bit expensive.
Tracy has had very good luck with the Flow Master Hush Power II. It
has about the best streamline combined with good sound suppression. Tracy
reported it not quite as good as the Spintech on the sound suppression but
better with less drag (and less cost).
Ed
----- Original Message -----
Sent: Wednesday, February 21, 2007 8:27
AM
Subject: [FlyRotary] Re: Another
exploding cigar??
Lynn, you may have the small idea for a round spintech
in your Borla. I had the thought after looking at the cone in Jegs
hot rod catalog. Has anyone tried one of these cones, the smallest one
is 3" in diameter and is $69. If it would stand the hammering it could
be mounted in a 6 or 7" piece of stainless pipe and should not be weight
restrictive. JohnD
----- Original Message -----
Sent: Wednesday, February 21, 2007
12:02 AM
Subject: [FlyRotary] Re: Another
exploding cigar??
I welcome any and all comments and
criticism, as I stated, I don't have a clue how this will work.
JohnD
I think this will be rejected out of hand. Just enough flow to get off
idle but no more. So now we have a 4" Borla stainless.
For the lower RPM the smaller core diameter would be OK. But the least
amount of restriction possible is far better.
The Spintech worked. It just had a bad shape. How about a round
Spintech?
Lynn E. Hanover
Check out free AOL.
Most comprehensive set of free safety and security tools, millions of free
high-quality videos from across the web, free AOL Mail and much
more.
|