|
|
I didn't remove the tube and flange piece from the center iron. Instead I cut off the plastic piece about 1 inch above the flange(just above the small breather pipe) and cut off the Renesis oil cap pipe about 1 inch below the cap. I used JB Weld and fiberglass to join the cap pipe to the flange pipe. It made a nice short oil filler system.
Dennis Haverlah
Bill Bradburry wrote:
I have been trying to figure out how to remove the plastic oil inlet
from the Renesis. I have the oil pan installed and the engine mounted
on Fred's plate, so I do not want to take a chance on dropping anything
down inside the engine that would require removal of the oil pan to
retrieve.
I assume that the inlet is just pressed (glued) in like the metal one is
on the earlier gens. Does anyone have experience that they could share
with me on this? I want to modify (shorten) an earlier gen inlet and
install the Renesis oil cap.
Thanks,
Bill Bradburry
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net/lists/flyrotary/
|
|