|
Kelly,
I'm going by the list of sizes provided (by the
other list) which have been amended a few times - it's hard to keep track.
Creavy also provided measurements which are wrong!!
OK I ordered for the outer coolant "O" ring, .093
cross section ( perfect)
11.230" ID ( which is smaller than the
original measurement of 11.340")this still just a tad big in diameter. I asked
Creavey to give me an indication of the size under that diameter. A size under,
may in fact, be too small - will have to wait and see.
I also ordered for the inner coolant "O"
ring, .093 ( they should have been .098, I discovered in earlier e-mails) and
yes, they were a bit sloppy in the groove, .098 would have been much better. The
diameter I have recorded here (and which I ordered) is 9.111" ID - way too
big!
How does that compare to your
information.
I'm in the process of checking ( as best I can) the
diameters from the housings.
I will also provide photos of the "O" rings in a
new housing. If we can get the right sizes they are an extremely good "O"
ring.
I have checked the cross section of the oil "O"
rings which are .118 x 4.330" and .093 x 4.680"- but have not checked
the diameter of either.
I figure if we can get a housing and some
standard "O" rings to Creavey, we stand a better chance of getting they exactly
right as they would have physical things to check against - should
have thought of this sooner - but I was trusting you guys over there to have got
it right by now.
George ( down under)
George,
All the O-rings (oil seal and side housing) or just the side
housing ?? Can you
give us the I.D. and cross section of the inner and outer coolent O-rings
that
you received.......I know that some on this list have received and are
using the
correct 0-rings !!
--
Kelly Troyer
Dyke
Delta/13B/RD1C/EC2
--------------
Original message from "George Lendich" <lendich@optusnet.com.au>:
--------------
OK! I just got my TES "O" rings - they look
beautiful, but don't fit - bugger!!
So the sizes provided by everyone are
incorrect.
Creavey Seal Coy. is in Olyphant
PA
is anyone near there that can drop them an old
damaged housing, so they can trial fit the correct size "O'
rings.
George ( down
under)
|