After spending two weeks trying to get hoses to fit into the available
space, I finally got the Meziere 337 installed, and amazingly, with no
leaks.  I did manage to ruin the threads on my fill tank.  I used
Permetex to seal the threads, but it didn't seem to work too well.  I
wanted to replace it with teflon tape, but when I removed the fitting
from the Moroso fill tank, the threads in the fitting were apparently
fused to the threads in the tank.  The AN12 to pipe fitting is ruined,
but I think I can re-thread the tank.

I found a company that has a good selection of AN fittings.  In
particular they had an AN16 Female-Female straight union which I
couldn't find elsewhere.  Using two of these with a 'T' allowed me to
connect my radiators togethere in a minimum of space.  BAT, Inc. in
Sarasoto, FL. Their web site is at  http://www.batinc.net/mocal.htm.
They don't have online ordering, but the phone salesman was quite
helpfull.  They have a lot of neat stuff including an AN16 one-way
flapper valve that's a lot nicer looking than the ones I bought.

With the pump running at 14 V, I get a current draw of  10.5 - 11 amps
which  is very close to what it was in the test I did earlier.  This
would indicate the flow is pretty close to 14 GPM as restricting the
flow would lower the current draw.  Next trip to the airport, I will
install the flow meter to verify.

At the rate I'm going, it looks like Ed will have his engine re-built,
installed and flying before I get mine started.

Bob W. (Moving slowly and unsurely)

-- http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)

 Homepage:  http://www.flyrotary.com/
 Archive:   http://lancaironline.net/lists/flyrotary/List.html

-- No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.10.2 - Release Date: 4/21/2005