Return-Path: Received: from femail6.sdc1.sfba.home.com ([24.0.95.86]) by ns1.olsusa.com (Post.Office MTA v3.5.3 release 223 ID# 0-64832U3500L350S0V35) with ESMTP id com for ; Wed, 15 Nov 2000 06:45:32 -0500 Received: from c656256a ([65.0.202.160]) by femail6.sdc1.sfba.home.com (InterMail vM.4.01.03.00 201-229-121) with SMTP id <20001115115311.HSIR2410.femail6.sdc1.sfba.home.com@c656256a> for ; Wed, 15 Nov 2000 03:53:11 -0800 Message-ID: <001101c04efa$fb5de880$a0ca0041@saltlk1.ut.home.com> From: "Robert Smiley" To: References: <002301c04e4e$23c98980$c80856d8@pavilion> <003f01c04eb8$d42f6a00$8e01560c@donnas> Subject: Re: another superfil question Date: Wed, 15 Nov 2000 04:55:42 -0700 X-Mailing-List: lancair.list@olsusa.com Reply-To: lancair.list@olsusa.com Mime-Version: 1.0 <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> << Lancair Builders' Mail List >> <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> >> Can you use superfill over micro? The answer is yes, I did it and only after the underlying micro has cured. Works OK. What I liked is that superfil was very good for finish work and I build it up to no more than 1/8 inch. Remember to heat it up with the gun if it stiffens up. It flows quite nicely. Bob Smiley, N94RJ robsmiley@home.com >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> LML website: http://www.olsusa.com/Users/Mkaye/maillist.html LML Builders' Bookstore: http://www.buildersbooks.com/lancair Please send your photos and drawings to marvkaye@olsusa.com. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>