Dom,
Yes, it is just 4 BID or similar bonded across the back side of the filler piece with a release from the spinner itself.
Chris

Sent from my spiffy iPhone

On Jun 7, 2013, at 2:11 AM, "Dominic V. Crain" <domcrain@tpg.com.au> wrote:

Thanks Chris.
Are the tabs glassed onto the back (inside) of the fillets, or otherwise fixed?
Cheers
Dom

Dominic V. Crain
domcrain@tpg.com.au
Phone 03-94161881
Mobile 0412-359320

On 07/06/2013, at 6:44 AM, Chris Zavatston <chris_zavatson@yahoo.com> wrote:

Dom,
These filler sections should have tabs with nutplates added such that they are secured to the spinner itself with screws. This will prevent the deformation you are seeing.

You can sort of make out the extra screws in some of the photos in this link
http://www.n91cz.com/Pressure/PlenumPressure.pdf

Chris Zavatson
N91CZ
360std
www.N91CZ.net

Sent from my spiffy iPhone

On Jun 5, 2013, at 2:55 AM, "Dominic V. Crain" <domcrain@tpg.com.au> wrote:

The two spinner cone fillets of fibre glass have over time bent outwards inflight and need to be replaced.
One of them flared out to the point where it was rubbing slightly on the propeller.
Any recommendations whether fibre glass should be used in making replacements, or switch to aluminium? (sorry, we spell and pronounce it differently up here).
Thanks,

Dom Crain
VH-CZJ

Dominic V. Crain
domcrain@tpg.com.au
Phone 03-94161881
Mobile 0412-359320


--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html

--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html

--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html

--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html