Another question for those who have gone before.

The L360 manual which I am using, in the section on the header tank construction, says that I may seal the inside of the tank with primer and then tank sealer (“PRC 1422” is suggested), or  with “two thick coats of resin” (page 11-34).

I am interested in what others have found to be the best way to go. As I live in Australia, the resin option is much easier than importing the sealer. However, I suspect there may be more to this decision than just the cost and simplicity advantages of resin. I would really appreciate any advice that others may be willing to offer.

Thanks again.

Rob Stevens

Perth

Western Australia.