Return-Path: <lancair.list-request@olsusa.com>
Received: from imo23.mx.aol.com ([152.163.225.67]) by truman.olsusa.com
          (Post.Office MTA v3.5.1 release 219 ID# 0-52269U2500L250S0V35)
          with ESMTP id com for <lancair.list@olsusa.com>;
          Sat, 20 Nov 1999 11:05:58 -0500
Received: from Bahahud@aol.com
	by imo23.mx.aol.com (mail_out_v24.4.) id x.0.70fd51e1 (4311);
	Sat, 20 Nov 1999 11:10:20 -0500 (EST)
From: Bahahud@aol.com
Message-ID: <0.70fd51e1.256821ec@aol.com>
Date: Sat, 20 Nov 1999 11:10:20 EST
Subject: Trailering
To: matt.hapgood@funb.com, lancair.list@olsusa.com
X-Mailing-List: lancair.list@olsusa.com
Mime-Version: 1.0

          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> 
>>
List:
I just read Matt's comment about breaking a rudder attachment during 
trailering his airplane.
A friend ofmine trailered a Cassut from the San Francisco Bay Area to Reno 
and on arriving he found a broken engine mount.
They welded the mount and raced.
He mounted a G-meter on the engine for the return trip and found the meter 
pegged at 10 G's.
Be careful Trailering an airplane.

Hank - San Mateo, Ca.


[In the glass industry the rule is "If it can move it will break", so
we take great pains to insure that all shipments are completely and
solidly immobilized.  I trailered my kit from S'n'F and followed that 
rule and didn't experience any problems whatsoever.  With a kit that's 
already on-gear, however, and assuming you're going to tie it down to 
the trailer with it standing on the wheels, my recommendation would
be to use binders (no ropes here) to compress the donuts and nose gear
strut to the point of eliminating any up/down motion of the airframe.  Don't
attach a tie-down to a single point on the airframe (like a rudder 
hinge bracket), but rather loop the binder strap around a major portion 
of the structure and tension from both sides... pulling down an inverted V
formed by the strapping restricts motion in two directions, and when
additional strapping is added it should always pull against the direction
of previously installed bindings.  If you can move the airframe without
imparting the same motion to the trailer the tie-down job is inadequate.  

So if you're going to move your project, get some straps and binders, don't
tie anything to small components, and keep the whole assembly immobile.
You should then be able to trailer it safely and without damage.  I 
hope this helps.

   <Marv>    ] 
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/Users/Mkaye/maillist.html
Builders' Bookstore:   http://www.buildersbooks.com/lancair
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>