On the LIV-P there is a rear seat back bracket P/N 350 that bolts to the top
of the landing gear box to hold the lower edge of the seat back (pressure
bulkhead). The angle of the seat back is 25 degrees aft of vertical. The
bracket has an angle of 14 degrees aft of vertical. The result is that the
only place the seat back (pressure bulkhead) touches the bracket is at the
very top edge of the bracket and moves the seat bottom forward about 1.5
inches. Do I have a miss manufactured bracket or is this normal?
If normal, what did you all do to address the problem?

Giff Marr
LIV-P/20B