Sender: <marv@lancaironline.net>
To: lml@lancaironline.net
Date: Wed, 08 Jun 2005 21:25:24 -0400
Message-ID: <redirect-989406@logan.com>
Received-SPF: none
 receiver=logan.com; client-ip=66.218.79.81; envelope-from=arrow54t@yahoo.com
From: Tammy and Mike Salzman <arrow54t@yahoo.com>
Reply-To: arrow54t@yahoo.com
Subject: Re: [LML] Infinity stick grip
In-Reply-To: <list-988636@logan.com>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii

Steve,

It isn't that hard.  All you need is ONE 29/64" hole the same size as
the hole in the bushing.  Then line up the holes and install the grip
through the hole.  It will then be locked in position.

You will need to slide the bushing farther down the stick than you have
it in the photo.  My grips came with very good instructions on how this
should be done.  If you don't have the instructions, 
go to: http://www.infinityaerospace.com/installation.pdf

I couldn't find any photos of my grips.  The infinity aerospace website
has some photos.

Good luck,
Mike Salzman
Fairfield, CA
LNCE


--- Steve Richard <steve@oasissolutions.com> wrote:

> I did some drilling/taping today.  Where/how did you drill for
> screws.  Any
> pictures?


__________________________________ 
Discover Yahoo! 
Get on-the-go sports scores, stock quotes, news and more. Check it out! 
http://discover.yahoo.com/mobile.html