My solution was to apply an epoxy slurry of
microballoons to build the into
symmetry.
Greg Nelson
I'm wondering how much micro as needed to get the
proper height? If Mario's wing is out 6deg at the trailing edge of the top
skin, that translates into something like 2.5 inches [ I had to draw it on
AutoCad to check but thats what it is assuming the wing's tip chord is ~24" as I
can't remember exactly what the tip chord is] That seems like a bit much
to micro over.
I would tend to lean towards temporarily bonding
the skin to the cradle even if it takes a few pound to pressure to
accomplish. Even with out heat you'll end up w/ a wing that has the proper
washout instead of 6deg of `wash-in'.
Jus' my 2 cents
Jarrett Johnson
235/320
|