|
I am trying to establish an accurate center line
for the hinges on the the horizontal stab. I contacted Redmond today and They
brought up a the following point.Even though you can split the difference
between the bottom skin and the top of the spar during layout, when you install
the top skin, there is a good chance that the bonding epoxy will be thicker than
the factory bond on the bottom skin. This would raise the top skin off the spar
a little and put it further away from the center line than the bottom skin, and
now the line is not in the center, it is closer to the bottom skin.
Has anyone had this problem and is there a better
way to find the centerline than splitting the difference at the hinge
points?
Thank You
Dale Wills
|