|
|
Angier,
I've included my right side horizontal tail access. The theme on my
plane is too close tolerances. I have to use some pretty creative tools
to torque the elevator pushrod connections. This is my first attempt at
sending digital shots. I have more if these don't induce too much dial
up agony or you desire to see the left side. My left side access hole has the 1/2" wide com attenna conveniently
running smack dab through the middle of the hole. I real bleeder when
assembling and disassembling. I enjoyed bending that little close out piece of al. It was my first
attempt at shaping metal.
On the subject of the HS...when it comes time to prime and paint, is
it best to remove the elevator hinges prior to paint or not?
I took my hinges off just to keep'm pretty. I then put a small piece of
tape over each of the holes to keep primer and gook away form the
nutplates. I didn't touch the tape till the final coat was completed.
I felt it cosmetically irrelavent.
Larry Henney
360LH
PS: Wife is beginning to consider letting me go to the Lancair BBQ.
Being from TX, I have to ask.... Is it good BBQ?
|
|