|
|
<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
<< Lancair Builders' Mail List >>
<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
To Doug, who asked about the source of the valves I used to replace
the brass water valves that came with the kit for the gear dump valve and the fuel shut-off valve. I must have hit a sore spot with this one
since I've received numerous emails asking the same thing. I'll repeat
the note I sent below:
*****************************************
Hi Jim: Here's the info you asked for re. replacement valves. The brand name is "NUPRO" and they are a "Swagelok" company. They apparently have distributors all over the place so, where ever you are located, you should be able to find them. You can find the local dist. by going to the Swagelok page on the net at: http://www.swagelok.com/index.htm and then it's an easy point and shoot to find what you need. Here in the South Bay section of the LA area, the distributor is Long Beach Valve & Fitting Co., at (562)494-6694. Ask for the catalog sheets for their P4T & P6T Series plug valves. They come in Stainless Steel or Brass, have a range of sizes and end fittings and offer several different colors for the handles. For reference, my hydro system is plumbed with 1/4" tubing so, for my landing gear dump valve (shunts high to low pressure circuit for emerg. extension) I used their number SS-2P4T4. For my fuel shut-off, I plan to use the SS-4P4T4 for the 3/8" lines there. Hope this gives you what you're looking for. Dan Schaefer *******************************************
Incidentally, I think I mentioned it in yesterday's post - the operating pressure for the ones I chose (SS material) is 3000 psi. Should be OK in the gear hydro system, as I've had that one installed for several years now, and I run an emergency
drop test at least once per month so it gets exercised fairly
often, and all is well.
Dan Schaefer
N235SP
____________________________________________________________________
Get free e-mail and a permanent address at http://www.netaddress.com/?N=1
|
|