<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
         <<  Lancair Builders' Mail List  >>
         <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>

We had a similar experience of burned up brake lines.  The initial dual brake system had a tendency of locking up when both pilot and copilot used them at the same time.  After taxiing with the brakes on for about 200 yards to get back to the hangar the brakes naturally heated up and melted the Nylon line.  I jumped out at our hangar just in time to put out the incipient fire (!) at the right brake line where it straps to the gear leg casting.  If you overuse your brakes in the 360 for any reason the nylon line will melt through if it is near a conductive heat transfer point from the brake rotor.  Stainless line near the brake area is the way to go I think.  Does anyone have a favorite kind or specification?  Also, is there a good place to connect the stainless line to the existing nylon line or should the whole line from the brake to the actuator be replaced?  (Brakes are on my top three wish list not to fail in the 360.)

Stu.

____
Stuart Seffern
Debbie Loiselle
916 Dane Street
Madison, WI 53713

E-Mail- RTWM02A@Prodigy.com