Subject: [FlyRotary]
Re: Renesis sensor wiring change
You are one of the few using the 3rd gen
sensor. I have not evaluated them but they do look very similar to the
Renesis sensor so may have similar characteristics. In any case, putting
the 1000 ohm resistor across it will not hurt anything (this includes the 2nd
gen sensor as well) so I would say it's a good idea to install them
on any installation. You will need to do this on both sensors since the
2nd & 3rd gen engines use 2 sensors. I will
be installing them internally on all EC2s from now on.
Tracy;
Can you give more specifics on this
addition? What is it expected to do? Where exactly does it go? Is this on
the reluctor pickup coils inside the CAS case; or can it be added to the wiring
at the EC2 end (3 wires)?
I assume I have a 3rd gen on
my 20B; but I’m never sure what Atkins may have changed.
Thanks,
Al