|
|
Thanks to input from Tracy, Marc and Dave I've been able to label most of
my
connectors.
Revised images are now at http://kgarden.com/cozy/engparts.htm
I'm left with three unidentified items and a couple of questions:
Tracy:
>Coolant feed to stock intake manifold. On an aircraft installation,
>this MUST be vented to vapor collection point. I would suggest a fitting
>screwed into [either of the temp sensor points] for this. The [temp
sensor
points]
>are otherwise not needed for our use. Ignore or plug.
What do you mean by "a fitting"? A pipe connecting the two?
I plan to run a cooling fan. Wouldnt the lower sensor be good for this?
If I plug the upper point or use it to vent the intake coolant return,
where
should I put my water temperature sensor?
Regards,
John Slade
I used a 3/8" hose from 1 to the WP housing. Either of the ports on the
waterpump housing would work fine.
There are so many options for water temp location that I can't enumerate
them all. My water temp sensor is a J type thermocouple (like most CHT
under the plug types) and is bolted under a washer to the back side of the
water pump. Anywhere that the sensor is exposed to the hot water path is
OK.
Tracy
|
|