Try the VDO VW Rabbit sensor (eGauges PN 323 088D). Same thread but
has almost zero protrusion. It has the correct resistance curve for the
existing EM2 calibration.
Tracy
----- Original Message -----
Sent: Thursday, October 12, 2006 5:37
PM
Subject: [FlyRotary] Short Temp
Senders
Hello All...
I ordered the following fitting with a 1/8"
port for
senders.
http://store.summitracing.com/partdetail.asp?part=RUS%2D670340&FROM=MG
I
have the EC2 which came with the VDO 323 057 1/8-27
300F sender. The
sensing portion of the sender is
1/2" long. Which on the -8 hose
pretty much closes
off the entire hose.
The threads on the fitting
are approximately 1/4"
deep.
Thus, does anyone know of a shorter
temp sender which
will not close off the hose? The ideal length
would
place the sensing portion of the probe only 1/8" or so
into the
hose.
Any advice is
appreciated.
Thanx...
-Scott
__________________________________________________
Do
You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection
around
http://mail.yahoo.com
--
Homepage: http://www.flyrotary.com/
Archive and
UnSub: http://mail.lancaironline.net/lists/flyrotary/