|
|
I found one (short body) at Chief Aircraft that is for up to 400F. It doesn't get below 500 ohms until 140 F, and I am using it for temperature input to the Blue Mountain unit. I will get more particulars on it tomorrow. I believe it was with the Mitchell guages, and it is a VDO sensor when it came.
Bill Schertz
KIS Cruiser # 4045
----- Original Message ----- From: "Scott" <squiggles@yahoo.com>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Thursday, October 12, 2006 4:37 PM
Subject: [FlyRotary] Short Temp Senders
Hello All...
I ordered the following fitting with a 1/8" port for
senders.
http://store.summitracing.com/partdetail.asp?part=RUS%2D670340&FROM=MG
I have the EC2 which came with the VDO 323 057 1/8-27
300F sender. The sensing portion of the sender is
1/2" long. Which on the -8 hose pretty much closes
off the entire hose.
The threads on the fitting are approximately 1/4"
deep.
Thus, does anyone know of a shorter temp sender which
will not close off the hose? The ideal length would
place the sensing portion of the probe only 1/8" or so
into the hose.
Any advice is appreciated.
Thanx...
-Scott
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net/lists/flyrotary/
|
|