|
Message
Another way to make an exhaust fit an unusual shape is to stack
more than one exhaust - making them out of square would help in this
regard. The outlet of one could be directly over the inlet of the other and
could be made the same area as the square tube.
Square tube has a greater surface area and the exhaust scrubbing the side
walls converts the noise into heat.
Then again that's more heat under the cowl!
Just a couple of ideas to throw around!
George (down under)
Would the inlet in the center of the can with a small outlet
on each end work?
Georges B.
Good thought, but I'm not the one who would
know. As I recall, this is a very familiar concept in RC engine
mufflers.
Rusty
|