|
|
Welcome Jim,
You've found the right place for rotary info. Of course we're both on
the other list (No not THAT other list) for BD-4 info.
Bob W. (You'll figure out what "the other list" usually means around
here soon enough.)
On Wed, 8 Jun 2005 06:48:27 -0500
"James Calamon" <n5658z@gvtc.com> wrote:
Hello everyone, I'm the new kid on the block and seriously looking at rotary power for my BD-4 project (check the link below). I need some help in getting started on information that I should bone up on before jumping into the morass of rotary engine building. I ordered the book on rotary conversions by Tracey Crook as a start, but would like input from experienced builders as to other recommended reading and reference material (i.e. books and web sights). Best Regards
Jim Calamon
N5658Z New Braunfles, Texas (BAZ)
"People may fail many times, but they become failures only when they begin to blame someone else" - Unknown
http://gvtc.com/~n5658z/
--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)
Prewired EC2 Cables - http://www.roblin-photo.com/cable/
|
|