Received-SPF: none
 receiver=logan.com; client-ip=206.191.0.250; envelope-from=ianddsl@magma.ca
Reply-To: <ianddsl@magma.ca>
From: "Ian Dewhirst" <ianddsl@magma.ca>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Subject: RE: [FlyRotary] Re: BAR GRAPH AIR/FUEL GAUGE
Date: Sat, 4 Jun 2005 23:22:30 -0400
Message-ID: <PAECKBMEOJHJJOCHELOCOEOFCJAA.ianddsl@magma.ca>
MIME-Version: 1.0
Content-Type: text/plain;
	charset="iso-8859-1"
Content-Transfer-Encoding: 8bit
Importance: Normal
In-Reply-To: <list-984980@logan.com>

Hi Yvon, I read about a fellow near Montreal with a rotary Zenith.  Is this
you?  I live in Ottawa, building an RV-8. -- Ian

-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]On
Behalf Of Géraldine Berger & Yvon Cournoyer
Sent: Saturday, June 04, 2005 11:09 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: BAR GRAPH AIR/FUEL GAUGE


Thank you Ian, very clear and satisfactory explanation.
To answer your last question: the system I purchased and use on my
Zenith monitors three signals: engine coolant temperature, throttle
position and engine speed. I found out recently that Holley now offers a
rich/lean indicator for use with their fuel injection systems. I am
requesting more info from them about this indicator, but its name
suggests a narrow band sensor.
Yvon

----- Original Message -----
From: "Ian Dewhirst" <ianddsl@magma.ca>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Saturday, June 04, 2005 9:39 PM
Subject: [FlyRotary] Re: BAR GRAPH AIR/FUEL GAUGE


> Hi Yvon,  I have attached a graph to help explain the problem.  In a
> nutshell: With a narrow band sensor ( blue lines ), you can really
> only tell
> for certain whether you are rich or lean, but not by how much. If you
> look
> at the graph, you can see that for a narrow band sensor, the 12.5:1
> AFR
> required for maximum power can give O2 voltage from 0.8 to 0.95
> (depending
> on exhaust gas temperature), yet this same range of O2 voltages can
> indicate
> mixtures from 10:1 to 14.5:1.  On the lean side it is a bit better but
> not
> much, the resolution is about one tenth of a volt.
>
> The graph also shows a wide band sensor ( red line ) with a wide-band
> sensor, 12.5:1 corresponds to 2.08 volts, and 2.08 volts means 12.5:1.
> Thus
> there is no ambiguity over AFR and voltages. We can measure any
> mixture in
> the range we are likely to use, from full power through to maximum
> economy.
> M
>
> I would not read too much into the data you get from your Cyberdyne
> other
> then rich or lean, how much lean or rich is a guess.  If you want an
> accurate reading instrument for piece of mind check out
> http://www.diy-wb.com/.  Otherwise if your engine is running smoothly
> and
> egt is normal you will be fine.
>
> Does the Holley Pro Charger use an oxygen sensor?
>
> -----Original Message-----
> From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]On
> Behalf Of Géraldine Berger & Yvon Cournoyer
> Sent: Saturday, June 04, 2005 7:17 PM
> To: Rotary motors in aircraft
> Subject: [FlyRotary] Re: BAR GRAPH AIR/FUEL GAUGE
>
>
> Hi Ian, I am flying with a Holley Pro-Jection two barrels fuel
> injection
> system and a homemade intake manifold.
> Yvon.
>
> ----- Original Message -----
> From: "Ian Dewhirst" <ianddsl@magma.ca>
> To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
> Sent: Saturday, June 04, 2005 5:49 PM
> Subject: [FlyRotary] Re: BAR GRAPH AIR/FUEL GAUGE
>
>
>> Hi Yvon, what type of fuel system are you using? -- Ian
>>
>>
>> -----Original Message-----
>> From: Rotary motors in aircraft
>> [mailto:flyrotary@lancaironline.net]On
>> Behalf Of Géraldine Berger & Yvon Cournoyer
>> Sent: Saturday, June 04, 2005 5:37 PM
>> To: Rotary motors in aircraft
>> Subject: [FlyRotary] BAR GRAPH AIR/FUEL GAUGE
>>
>>
>>   I fly a Zenair Zenith 200 with a l986 13B.  I have installed a
>> Cyberdyne Instruments bar graph air/fuel gauge (P/N 7009). The O2
>> sensor
>> is located ~31 inches from the exhaust ports. The O2 sensor is not a
>> Cyberdyne Instruments part. It is an aftermarket universal single
>> wire
>> sensor. The readings of the air/fuel gauge are baffling me. At idle
>> of
>> 1100  rpm and MP of 14.1-14.2 inches/mercury, the air/fuel gauge
>> shows
>> a
>> rich condition of ~12.7:1. That is where the engine runs best at
>> idle.
>> At full power static of 5200-5250 rpm and MP of ambient (~30
>> inches/mercury), the air/fuel gauge reads rich ~13.2:1. However, when
>> I
>> retard the throttle to 3000-3500  rpm, at a MP of 17.0-17.1
>> inches/mercury, then the air/fuel gauge reads lean at ~16.0:1. The
>> engine runs quite evenly at all power settings but I wonder if the
>> variations in fuel mixture are normal and safe?
>> Yvon.
>


>>  Homepage:  http://www.flyrotary.com/
>>  Archive:   http://lancaironline.net/lists/flyrotary/List.html