|
|
John Slade wrote:
Chapter 29 "Flight Testing part 6" is a morning staple at my office ;-)
I trust that Chapter 30 will follow? -- Ian
Yea. Right after Flight Testing parts 7, 8, and 9 :)
Question for Tracy - should Buly's early edition EM2 communicate with my
upgraded EC2?
If so, maybe the fault is in the female connector, rather than in the
harness. I've removed the plug cover and moved each wire individually and
can't reproduce the problem.
John
Pins can partially back out of the housing & can be very hard to detect. One mating connector might not make contact on the problem pin and another might work just fine, due to differences in brand, mfg tolerances, etc.
Also, either the shell of the connector on the cable or the panel in which the chassis side connector is mounted can prevent full seating of the connector.
Can you get to both ends (inside both components) to probe for continuity from pc board to pc board with an ohm meter? Don't forget to remove power first (right, Bernie?)
Charlie
|
|