Received-SPF: none
 receiver=logan.com; client-ip=211.29.133.165; envelope-from=lendich@optusnet.com.au
Message-ID: <002a01c561ad$d1ed8d50$300aecdc@george>
From: "George Lendich" <lendich@optusnet.com.au>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
References: <list-963724@logan.com>
Subject: Re: [FlyRotary] Prewired EC2 Cables
Date: Thu, 26 May 2005 14:46:02 +1000
MIME-Version: 1.0
Content-Type: text/plain;
	charset="iso-8859-1"
Content-Transfer-Encoding: 7bit


> I'm contemplating offering prewired cables for Tracy's EC2.  I've been
> in the electronics field for over 40 years so soldering and cabling are
> easy for me.
>
> I would prewire the 15 and 37 pin connectors to your specified length.
> Other wires would be long enough to be cut off and terminated by you.
> Wires would be tefzel (M22759/16) or better and each wire would be
> clearly marked.  Everything would be done to the specs in Tracy's
> manual.
>
> Using my installation as a reference, I would make the unterminated
> wires that go under the insturment panel 5 feet long and those going to
> the engine compartment 10 feet long.  Length from the 15 pin
> connector to the 37 pin connector is 36 inches.  Based on that, the cost
> would be $95 but this would be adjusted for different lenght
> requirements. These lengths should leave enough wire for most
> installations.
>
> Also, for the canard community, I would be willing to cable anything up
> to your specifications, but because of the long runs and sensitivity to
> noise I wouldn't want to gurantee sucess in using the cable.
>
> Is there any interest in such a service?
>
> Bob White

Bob,
What a great service, I wish you the best  of success as the price sure is
right. Will you send to Australia.
George ( down under)