|
|
At 06:02 PM 5/25/2005, you wrote:
Well chaps, I have to pick out a Renesis motor for a mate in Western Australia.
I bought my Renesis from the same fellow. Say "g'day" to Rupert for me. :^)
I popped over to the Jap motors warehouse and there was about 50 of them just sitting on the floor. Looked like they had just been pulled out of the container. Most looked pretty good - looked like new one would say!
Just looking at them the cost $2,300 Aust (about $1,750 US @ 76c Aust in the US dollar), isn't that cheap I figured that would make you chaps cry.
That's what Rupert charged me, but I had to pay shipping to the USA and paperwork costs.
I wonder what the importer is paying for them! That would make me cry!!
Tell me if I'm wrong but apparently the 6 port is the more powerful compared to the 4 port, but wouldn't the 4 port be easier to make a inlet manifold? Please comment anybody!
I also note the very very nice 75mm ( 3") throttle butterfly on the inlet manifold 6 port ( bloody beauty).
It is gorgeous, isn't it.
I liked the look of the fuel rails too. Nice coils as well.
I bought the six port, but I just picked it because it is rated at a higher HP. I wonder if there is anything different internally?
Bill Dube'
There certainly is some nice work on them Renesis.
George ( down under)
See if you can glean any more information about what they were used for from Rupert.
Bill Dube'
|
|