|
|
Rusty,
Mine does not, but there is a pair of holes - above and below the throttle plate - I think they were intended to be connected via an idle bleed motor. I planned to seal them off with a blank plate, where the motor/solenoid went. It should be a trivial matter to drill through the plate into the lower cavity to use that as a MAP port.
I won't be doing that on mine; I want to sample the intake pressure about mid-runner on each of the four tubes.
Dale R.
Russell Duffy <13brv3@bellsouth.net> wrote:
Did you mean the bolt pattern. Mine (nom. 60mm bore)
is pretty close to 90mm x 90mm.
Thanks Dale. The overall dimensions is what I was after, to the 90mm x 90mm
bolt pattern gives me a pretty good idea. Does it have a MAP port?
Cheers,
Rusty
|
|