----- Original Message -----
Sent: Sunday, April 24, 2005 12:48
PM
Subject: [FlyRotary] Re: Apex Slot Wear/
Grinding for 3mm Seals
In a message dated 4/23/2005 7:32:41 PM Pacific Standard Time,
keltro@att.net writes:
It was mentioned that the hardened layer at the rotor
tips was lost due to grinding for the 3mm
seals........Do you know what
hardening process is used (induction, etc) and whether
it could be
restored........Your take on this please Lynn or
anyone !!
Kelly, If the tips are induction hardened then they mcould be re-done
after machining. Nitrideing is another possibility.
Bill Jepson