|
|
Hi Ernest,
Yes, the WP136 is what I'm using. We can probably get pretty close as
I earleir meaured the maximum head pressure to be 6 psi, and maximum
flow of 16 GPM. These measurements were with 40 F tap water, so some
adjustments would have to be made. I'm not claiming a high accuracy on
these measurements anyway. :) The lower flow rates are probably only
good to +/- 1/2 GPM at best.
Bob W.
On Thu, 03 Mar 2005 10:28:44 -0500
Ernest Christley <echristl@cisco.com> wrote:
Bob White wrote:
>Here is the raw data without any corrections for anything. Data is
>Voltage, current, flow, and temperature. Temperature was measured with
>a thermocouple on the output fitting on the engine just before the flow
>meter.
>
> >
Bob, which pumps were you using again. Was it the WP136. If we can get the flow graphs for the pumps, then we can put some real world numbers on the graphs that William sent. Hopefully making future prognostications more accurate.
--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)
|
|