|
|
Once again duct tape rides to the rescue.
This tab is 4"x1 1/8"x.032 Al and with an 8º bend.
I didn't get around to scanning the ball for a bit but back up at 200kts there was obvious improvement.
Ball centered with no help from my left foot. If I had white duct tape I'd be tempted to 'set it and forget it' as my carpenter would say.
But I'll round the corners, polish, and try the silicone approach.
Scott's internal rudder trim is certainly more elegant, but I'm out of the building and into the flying mode!
At least until I get back to my shop and my half built chopper starts to wink at me.
Angier Ames
N4ZQ
9.2hrs and counting...
IMG_0354.jpg
IMG_0355.jpg
IMG_0356.jpg
|
|