Sender: <marv@lancaironline.net>
To:  lml@lancaironline.net
Date: Mon, 19 Nov 2012 08:23:28 -0500
Message-ID: <redirect-5887261@logan.com>
Received-SPF: none
 receiver=logan.com; client-ip=66.94.237.88; envelope-from=lancair1@bellsouth.net
From: "Doug" <lancair1@bellsouth.net>
References: <list-5885952@logan.com>
In-Reply-To: <list-5885952@logan.com>
Subject: RE: [LML] Unusual LIVP Manifold Pressure Reduction with Altitude Climb: Why so much?
MIME-Version: 1.0
Content-Type: text/plain;
	charset="us-ascii"
Content-Transfer-Encoding: 7bit
Thread-Index: AQFVerv1VVocRGygFxnsy5wfJWdqyZjgao2Q
Content-Language: en-us

Might be a waste-gate failure? Happened to me once, under similar
circumstances...

Douglas W. Johnson, MD PA


Subject: [LML] Unusual LIVP Manifold Pressure Reduction with Altitude Climb:
Why so much?

On a recent flight to Chicago, my MAP during WOT climb was normal and ample
all the way to cruise FL220, at which time I pulled throttle back to 31.5",
dialed down RPM to 2350 (which increases MAP some, so readjust) and "Big
Mixture Pull" to LOP 16.4gph.  All very normal.  Cabin Pressure 5 psid.

On my return, departing during 30*F temps and cleaning some overnight
rain-ice off the wings (via hanger heat), I climbed out of Chicago WOT and
had full MAP at departure, but then observed a decreasing MAP during climb
(numbers are below).  Details below.

I leveled off at 17,500 and observed WOT ~31" MAP and RPM 2690, 32.3 gph,
all engine parameters normal.  I did not reduce throttle, I dialed back RPM
to 2350, and observed MAP reduce to 24" (and cabin altitude climbed with 1.5
psid).

T/O 		WOT 38.5" 	RPM 2670 	FF 43 gph
8000'	WOT 37"	 	RPM 2670 	FF 41 gph
12000'	WOT 36"	 	RPM 2670 	FF 38.5 gph  	Cabin 4.1 psid
15000'	WOT 34"	 	RPM 2680 	FF 35.1 gph
16000'	WOT 33"
17500'	WOT 31.8" 	RPM 2690 	FF 32.3 gph
	adjusting into cruise settings:
17500' 	WOT 24"	 	RPM 2350 	FF 23.9 gph	Cabin 1.5 psid

At home, I pulled the cowling, inspected everything, pressurized the
induction system, inspected the already clean filter, check the Alt Air
Door, checked turbos and waste gate controller (on bench), checked
compressions: everything normal and in great working condition.

Today I test flew back to 17,500' WOT max RPM (full rich) and observed the
same behavior.  This excludes intake ice or frozen alternate air door.

Also found that if I diverted incoming bleed air (feet vs defrost), the MAP
remained same.  As expected, if I occluded incoming air, MAP increased to
28" but cabin (of course) climbed to >12,500'.  If I selected HOT air, MAP
remained same; if I selected COOL air, MAP rose 0.5".  None of this is
surprising, siphoning off the Upper Deck pressure.

Interestingly, while at 17500', there was no change in MAP when the throttle
cable was moved from WOT (all in) to more than 2" throttle pulled out.

Descending back to 8000', the numbers were as above for that altitude, with
access to 37" MAP WOT and higher cabin psid.  The plane has historically
been able to maintain >36.5" MAP WOT up to FL210 (or maybe a bit higher)
before MAP would start dropping off as turbos were max'ing out.

What suggestions can you make regarding this engine performance/behavior
issue?

Jeff L
LIVP


--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html