<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
>>
Not sure who to respond to because there is no sign-off name under the
subject note.

I use an air powered 90 degree die grinder with a 3" diameter cut-off wheel
to cut through fiberglass, prepreg and aluminum sheet.  There are also
several diameters of sanding discs available to bring any unusual shaped
panel down to the pencil line after roughing-out with a 3" cut-off wheel.
Additionally, there are polishing scotchbrite type discs available to do
anything from light touch polishing of all kinds of metal to actually
removing metal from about anything a builder contends with.  A good air
supply is required.  Snap-on has a complete line of airtools and so does
Harbor Freight, as do most tool suppliers.

Jerry Grimmonpre' LNC2
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/Users/Mkaye/maillist.html
LML Builders' Bookstore:   http://www.buildersbooks.com/lancair

Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>