Sender: <marv@lancaironline.net>
To:  lml@lancaironline.net
Date: Wed, 08 Jun 2011 08:25:10 -0400
Message-ID: <redirect-5013371@logan.com>
Received-SPF: pass
 receiver=logan.com; client-ip=24.116.0.234; envelope-from=bbreen@cableone.net
Subject: Re: [LML] hot start procedures?
References: <list-5012360@logan.com>
From: Berni <bbreen@cableone.net>
Content-Type: text/plain;
	charset=us-ascii
In-Reply-To: <list-5012360@logan.com>
Content-Transfer-Encoding: quoted-printable
Mime-Version: 1.0 (iPad Mail 8H7)

John:

I use the following procedure which works about 95% of the time on the first=
 try:
Wide open throttle
Fill rich mixture
Low boost on for 6 seconds...then boost off
Attempt start with one finger ready to turn on low boost and your right hand=
 on the throttle ready to retard when engine fires off
When engine does fire off, immediately turn low boost on and retard throttle=
=20

Good luck!


Sent from my iPad
Berni Breen
Bbreen@cableone.net

On Jun 7, 2011, at 1:18 PM, John Hafen <j.hafen@comcast.net> wrote:

> Gents:
>=20
> What have you found to be the best hot start procedure for a TSIO 550, wit=
h mags, in an IVP?  I'm not talking immediately after engine shut down, but s=
hut down on a hot tarmac after 30 to 40 minutes so the fuel lines are nice a=
nd hot and boiling the internal fuel.
>=20
> Thanks,
>=20
> John
> IVP 413AJ
>=20
>=20
>=20
> --
> For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.htm=
l