Bill,   as far as moving the Hydraulic pump....consider if you might ever want an aux fuel tank (or tks tank) right there behind the pressure bulkhead.  

On Mar 9, 2011, at 4:47 PM, Bill Wade wrote:

>    I was getting ready to start on the IV-P baggage area- my kit doesn't have the "elephant butt" wheel housings so I received two sheets of 1/4" material and no instructions. Thankfully I have a number of photos from different sources.
>  
>  The sheets, P/N 1026A  and 1026B vary in the fabric orientation- A is 0-90 and B is +/-45 degrees. I asked the factory and was told to use the 0-90 for the baggage area, but the photos of various projects show everyone using the +/-45 material. Could those who have gone before confirm what they've used and where?
>  
>   Also, I checked the archives and found some discussion about moving the hydraulic power pack forward to the area behind the pressure bulkhead. Is that a good location in terms of W&B?
>  
>   Thanks very much-  Bill Wade