Ralf,

Your problem was addressed by Lancair Service Bulletin # SB052-1299.  To
correct mine, I measured the length required and fabricated an aluminum
sleeve to limit the flap cylinder travel.

Ed Smith
Chesapeake, VA



-----Original Message-----
From: Lancair Mailing List [mailto:lml@lancaironline.net] On Behalf Of
bronnenmeier@GROBSYSTEMS.COM
Sent: Friday, July 23, 2010 9:18 AM
To: lml@lancaironline.net
Subject: [LML] left over flap cylinder stroke 4P

Dear subscribers,

During the final assembly of my 4P flap actuating mechanism I found that the
cylinder has more stroke than required in order to make full flap travel.

I think that I would need to add a hard stop somewhere to limit the cylinder
stroke and not bend the push rods or something else.

Any advise/pictures/sketches would be greatly appreciated.

Thanks

Ralf



--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html