Mailing List lml@lancaironline.net Message #53583
From: Burr Bryan <bjburr@mwheli.com>
Sender: <marv@lancaironline.net>
Subject: Re: [LML] Re: Fuel Pressure
Date: Tue, 01 Dec 2009 06:31:04 -0500
To: <lml>
Thanks for your comments Paul.  That is why I thought it important to mention that the fuel flow remained normal and unchanged.  If the fuel flow changed up or down with the increase in pressure I would certainly be looking at a true mechanical problem.  Especially with an increase in pressure and a reduction in flow.  This would indicate at restriction.  But I certainly will be looking at everything.

Bryan
On Nov 28, 2009, at 3:31 PM, Paul Bricker wrote:

Bryan,
If you really have excessively high fuel pressure (not a bad sender) the
fuel flow can go high enough to cause a major power loss. One known failure
mode is in the aneroid in the fuel pump. It is designed to maintain proper
pressure as the outside pressure goes down with altitude. It can fail to
maximum possible pressure, causing excessive fuel flow, power loss, black
smoke, etc. During take-off this can be a critical failure. Always monitor
fuel flow, and, if you have to, control it manually using the mixture
control until you can land and fix it.
Paul Bricker
N63PB

-----Original Message-----
From: Lancair Mailing List [mailto:lml@lancaironline.net] On Behalf Of Burr
Bryan
Sent: Saturday, November 28, 2009 9:55 AM
To: lml
Subject: [LML] Fuel Pressure

Gents,
Regarding a Continental TSIO550E, climb power 34.5" RPM2500, Full rich
33 gph.
During a recent flight I experienced higher than normal fuel
pressure.  The fuel flow was unchanged 33 gph as were the egt and cht
temps.  Normally my fuel pressure is 36 psi but it climbed to 40 psi
and the Chelton audible warning to "check engine" came on.  It is set
to come on at 39.

Typically I would be suspicious of high pressure if fuel flow had
dropped as this could indicate a restriction.  But everything else
remained normal.  Low pressure could indicate several things such as
broken line, failing pump, restriction, etc.

So what are the concerns with high fuel pressure?  What are the
trouble shooting steps?  I suspect a possible wiring or sending unit
issue?

Thanks
Bryan Burr
N132BB

--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html


--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html

Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster