Looking at the page 15-28 Rev 6/04-01-99 in "Lancair 320FB manual" where Figure-9a is depicted, it's specified there that with full elevator down (11 degrees) the Elevator Idler arm (which supports the Bob weight) to be 1/4" from Rear push/pull tube. My question is:

Would that be acceptable to have this distance at 0.59"
Or is it absolutely critical that I have it at 0.25"

I am maxed out on push-rods travel at this point.

Thank you in advance for your suggestions and advice.
Regards,
Garry V. Laznicka
L-360c 85%