Wanted to survey the folks out there who have installed Lightspeed ignitions and resolved the issue of passing the crank sensor wire with the large d-sub connector through the firewall then closing and sealing the hole..

 

Even after removing the D-sub shell, it seems I will still need to make a hole in my firewall that is about 1.25” in Diameter. Can some other builders suggest and or send me some photos of the methods they used to neatly finish and cover that pass through? I did pick up a few firewall shields from Spruce, but was thinking that perhaps there are other ways that result in a more “robust and finished” appearance.

 

Thanks

 

Jay Sabot