Try to reach Mark Davis across lml…

 

Regards

Lino

 

-----Ursprüngliche Nachricht-----
Von: Lino Missaggia (G) [mailto:lino.missaggia@m-engineering.net]
Gesendet: Dienstag, 21. August 2007 21:38
An: 'Mark Davis'
Betreff: Flap-Box-Failure

 

Dear Mr. Davis,

 

Thank you for your Mail, I’ll try an email again! ;-)

 

I saw, that you switched the selector from position 3 to 4, expecting to set the device in Auto-Mode

BUT: the position 4 sets the 5.th step (flaps full up) when using 5 steps in flap-movement!

The correct switch positions for auto-mode are as follows:

Position            Steps for flap-movement

5                                            3 steps (0, 1, 2)

6                                            4 steps (0, 1, 2, 3)

7                                            5 steps (0, 1, 2, 3, 4)

 

Hope you will receive this email, because the others didn’t work!?

 

I will make a wiring diagram for the resistors to connect the sensor-outputs and email or fax it to you soon!

You should then review it, perhaps I have misunderstood something with your voltages…