Sender: <marv@lancaironline.net>
To: lml@lancaironline.net
Date: Tue, 07 Aug 2007 16:34:23 -0400
Message-ID: <redirect-2248665@logan.com>
Received-SPF: pass
 receiver=logan.com; client-ip=209.226.175.110; envelope-from=ian.crowe@sympatico.ca
From: "Ian Crowe" <ian.crowe@sympatico.ca>
References: <list-2244348@logan.com>
Subject: Re: [LML] Outback Flap wiring
MIME-Version: 1.0
Content-Type: text/plain;
	format=flowed;
	charset="iso-8859-1";
	reply-type=response
Content-Transfer-Encoding: 7bit

I used the diagram in the book and reversed the sense if I remember 
correctly.  At any rate it never became an issue.  Try reversing the wires 
for up/down and see what happens!
----- Original Message ----- 
From: "Doug" <lancairav8r@gmail.com>
To: <lml@lancaironline.net>
Sent: Sunday, August 05, 2007 8:10 PM
Subject: [LML] Outback Flap wiring


> Does anyone have a correct wiring schematic for the Outback Flaps on a 
> Lancair 360? The manual is for a standard build flap system and as far I 
> can tell it doesn't work with the Outback setup. Example: In the standard 
> flap setup the manual makes a big deal about identifying which wire (red 
> or black) makes the actuator extend and put the flaps down. In the 
> Outback, the extension of this actuator brings the flaps up. No 
> supplemental diagram was included with the Outback directions.
>
> Thanks
>
> Doug
>
> Doug Waddingham
> Centennial, CO
> --
> For archives and unsub 
> http://mail.lancaironline.net:81/lists/lml/List.html
>
> __________ NOD32 2441 (20070807) Information __________
>
> This message was checked by NOD32 antivirus system.
> http://www.eset.com
>
>