Mailing List lml@lancaironline.net Message #39729
From: Tom Gourley <tom.gourley@verizon.net>
Sender: <marv@lancaironline.net>
Subject: Re: [LML] LEDs-Xmit
Date: Thu, 01 Feb 2007 01:00:19 -0500
To: <lml>
The other good thing to do, if you've put a lot of money in your stack, is to throw out any RG 58 or even the RG 400, and replace it with Andrew FSJ1-50 coax; there's no better on the market. You'll tx  an rx much farther, with lots less nulls in your pattern, because of its low loss and solid outer conductor with essentially NO leakage!
 
Paul,
 
Just curious, how did you determine that FSJ1 will allow you transmit and receive much farther?  Comparing the specs of FSJ1 with RG400 shows that the difference in loss over 10' of coax at com frequencies is about 0.25dB.  That's trivial.  And I was under the impression that nulls in the pattern were primarily the result of the antenna and its physical installation.
 
Tom Gourley
 
 
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster