Mailing List lml@lancaironline.net Message #39201
From: Marvin Kaye <marv@lancaironline.net>
Subject: Re: [LML] LNC2 Lancair 320 Hydraulic System Bleeding
Date: Thu, 28 Dec 2006 21:14:22 -0500
To: <lml>
Posted for "Bob B." <rbelshe@comcast.net>:
 
 A couple of years ago I went through the same problem,  with the pump
 "blipping"
 about every 4-5 seconds.  In my case it only happened when the gear was
 down.
 
 The problem was the dump valve.  I tested everything else first because I
 didn't believe the dump valve would only leak in one direction.
 
 In my installation it was easy to test by removing the dump valve and
 closing off the lines with some spare fittings.  This cured the "blipping".
 Lancair sells a valve rated at higher pressure, but it is slightly larger
 and a lot heavier.  I chose to replace mine with the same valve, figuring I
 can replace it again in 8 years if need be.
 
 Bob Belshe
 Moraga, CA
 Lancair 235/320  530 hrs.
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster