|
|
Posted for "Wally Bestgen" <whiskeyb@sbcglobal.net>:
From time to time there is some interest in Rudder crossover gears. My
solution was to have the gears machined to fit at any position on the rudder
crossover bars. The results are a gears that can be installed in a few
minutes with out drilling into the crossover bars. The gears side is steel
and the clamp side is aluminum to save weight. There are two allen screws
that tighten to hold the gear securely to the bar. If anyone in interested in
a set of these gears I will have them made up. I will need to have ten sets
made and the cost is $160.00 delivered to your door. If you are interested
please e-mail me at whiskeyb@sbcglobal.net
I also have two condensate drains for air-conditioning systems. This is
machined out of aluminum and have "o" ring seals. They are black anadozided
and supplied with delrin mounting brackets. The ping pong ball acts a check
valve to seal the pressurization. the cost is $100.00
If you are interested please e-mail me at the above e-mail address.
Wally Bestgen
|
|