|
Colyn
Lancair has a kit to do this I think, but it's easy
to do yourself. I used stainless hard-line 3/16 from a local
high
performance bake shop, the stainless will slid up
the
gear leg and past the pin at the top easily.
If your going
to go this way you will need to make a special tool
to
remove and reinstall the lines inside the gear leg
foot. I
have one I would lend you or will tell you how
to make one(it's easy). If you have any questions email or
call
Regards
Art
909-931-2727
----- Original Message -----
Sent: Thursday, May 26, 2005 1:11
PM
Subject: [LML] part numbers for brake
lines
I just read through many posts about brake
lines.
I'm looking for specs/part #'s for:
- aluminum hard
line
- stainless hard
line
- stainless braided flex
line
I did pick up the dhi information that was
posted.
thanks,
Colyn
|