|
|
Posted for "Ron Raby" <ronr@advanceddesign.com>:
George
The square cutout lines up with the forward fins. The top of the hole starts
at the top of the outboard fins. The bottom of the hole ends just before the
bottom of the out board fins. It is hard to get a good picture of this
assembly. The scoop is 3.5" wide about the same as the outboard fins.
The picture from below is typical of the baffling pieces that run down the
side of the bottom fins. This is what I think I need to replace with the
boxed in piece's.
Thanks
Ron Raby
|
|