|
|
Bill,
If the pump works the same as on the 320's, there is an internal relief valve that is set somewhere between 1,500 and 1,800 PSI.
I sent my pump to the pump factory along with new gauges from Lancair and had them rebuilt the pump and calibrate the gauges. The total charge was $75.
If our pumps are the same, contact:
Edward Van Hecke
Oildyne - Oil Dyne
voice: 763-531-3578
5520 North Hwy 169
Minneapolis MN 55248
From: billhogarty <billhogarty@direcway.com>
Date: October 30, 2004 9:50:13 PM EDT
My hydraulic pump has started to run continuously at 900 PSI instead of shutting off at 1100 PSI
I should mention that the gear operates normally but then the pump runs continuously without going above 900 PSI. This happens in both the up and the down gear position.
.
.
billhogarty@direcway.com
--
Lorn H. 'Feathers' Olsen, MAA, DynaComm, Corp.
248-345-0500, mailto:lorn@dynacomm.ws
LNC2, O-320-D1F, N31161, Y47, SE Michigan
|
|