Return-Path: Sender: "Marvin Kaye" To: lml@lancaironline.net Date: Fri, 05 Nov 2004 09:47:24 -0500 Message-ID: X-Original-Return-Path: Received: from www.dynacomm.ws ([198.22.63.66] verified) by logan.com (CommuniGate Pro SMTP 4.2.5) with ESMTP id 499887 for lml@lancaironline.net; Fri, 05 Nov 2004 09:34:38 -0500 Received-SPF: none receiver=logan.com; client-ip=198.22.63.66; envelope-from=lorn@dynacomm.ws Received: from [10.0.1.202] (adsl-69-209-129-102.dsl.sfldmi.ameritech.net [69.209.129.102]) by www.dynacomm.ws (8.10.2/8.10.2) with ESMTP id iA5EY3421125; Fri, 5 Nov 2004 09:34:03 -0500 Mime-Version: 1.0 (Apple Message framework v619) Content-Type: text/plain; charset=ISO-8859-1; format=flowed X-Original-Message-Id: Content-Transfer-Encoding: quoted-printable X-Original-Cc: billhogarty@direcway.com From: "Lorn H. Olsen" Subject: Re: L-IV Hydraulic Problem X-Original-Date: Fri, 5 Nov 2004 09:34:03 -0500 X-Original-To: Lancair List X-Mailer: Apple Mail (2.619) Bill, If the pump works the same as on the 320's, there is an internal relief=20= valve that is set somewhere between 1,500 and 1,800 PSI. I sent my pump to the pump factory along with new gauges from Lancair=20 and had them rebuilt the pump and calibrate the gauges. The total=20 charge was $75. If our pumps are the same, contact: Edward Van Hecke Oildyne - Oil Dyne voice: 763-531-3578 5520 North Hwy 169 Minneapolis MN 55248 > From: billhogarty > Date: October 30, 2004 9:50:13 PM EDT > > My hydraulic =A0pump has started to run=A0continuously at 900 PSI = instead=20 > of shutting off at 1100 PSI > =A0 > I should mention that the=A0gear operates=A0normally=A0but then=A0the=20= > pump=A0runs continuously without going above 900 PSI.=A0 This happens = in=20 > both the up and the down gear position. > . > . > billhogarty@direcway.com -- Lorn H. 'Feathers' Olsen, MAA, DynaComm, Corp. 248-345-0500, mailto:lorn@dynacomm.ws LNC2, O-320-D1F, N31161, Y47, SE Michigan